18-9
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter18 DLPs F300 to F399
DLP- F307 Create Login Node Groups
•Auto—Uses the first string received from the port at the other path trace end as the current expected
string. An alarm is raised when a string that differs from the baseline is received. For STM-N ports,
Auto is recommended because Manual mode requires you to trace the circuit on the Edit Circuit
window to determine whether the port is the source or destination path.
•Manual—Uses the Current Expected String field as the baseline string. An alarm is raised when a
string that differs from the Current Expected String is received.
Step7 If you set the Path Trace Mode field to Manual, enter the string that the STM-N port should receive in
the New Expected String field. To do this, trace the circuit path on the detailed circuit window to
determine whether the port is in the circuit source or destination path, then set the New Expected String
to the string transmitted by the circuit source or destination. If you set the Path Trace Mode field to Auto,
skip this step.
Step8 Click Apply, then click Close.
Step9 Return to your originating procedure (NTP).
DLP-F307 Create Login Node Groups
Step1 From the Edit menu in node view, choose Preferences.
Step2 Click the Login Node Group tab.
Step3 Click Create Group.
Step4 In the Create Login Group Name dialog box, enter a name for the group.
Step5 Click OK.
Step6 In the Members area, type the IP address (or node name) of a node you want to add to the group. Click
Add. Repeat this step for each node that you want to add to the group.
Step7 Click OK.
The next time you log into an ONS15600 SDH, the login node group will be available in the Additional
Nodes list of the Login dialog box. For example, in Figure18-2, a login node group is created that
contains the IP addresses for Nodes 1, 4, and 5. During login, if you choose this group from the
Additional Nodes list and Disable Network Discovery is not selected, all nodes in the figure appear. If
the login group and Disable Network Discovery are both selected, Nodes 1, 4, and 5 appear. You can
create as many login groups as you need. The groups are stored in the CTC preferences file and are not
visible to other users.
Purpose This task creates a login node group to display ONS15600 SDH nodes that
have an IP connection but not a DCC connection to the login node.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
NTP-F129 Log into the ONS 15600 SDH GUI, page 3-5
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher