18-30
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter18 DLPs F300 to F399
DLP- F331 View ASAP POS Ports History PM Parameters
Step4 View the Port # column for the port that you want to monitor.
Step5 The Tx and Rx bandwidth utilization values for the previous time intervals appear in the Prev-n columns.
For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15600 SDH Reference Manual.
Note To refresh, reset, or clear PM counts, see the “NTP-F184 Change the PM Display” procedure on
page 8-2.
Step6 Return to your originating procedure (NTP).
DLP-F331 View ASAP POS Ports History PM Parameters
Step1 In node view, double-click the ASAP card where you want to view PM counts. The card view appears.
Step2 Click the Performance > Ethernet > POS Ports > History tabs (Figure18-8).
Purpose This task enables you to view historical PM counts at selected time
intervals on an ASAP card and port to detect possible performance
problems.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher