Line 6 GearBox 3.7 – UsingYour Line 6 Hardware

TonePort KB37

Connect any line level input source for monitoring to the Stereo Monitor In

 

Connect up to two standard toggle

 

or momentary pedal switches into

Connect any line level input

the Footswitches jacks for remote

source that you want to

control of GearBox and audio

record into the Line Inputs

application

Connect your electric

Guitar or Bass

Connect

Connect up to two

Connect your USB cable

your stereo

from your computer’s USB

Headphones

Microphones

port.*

Connect the Analog Outs

Connect to the S/PDIF input

to your audio monitors

of an external device to send

 

TonePort’s output digitally

Connect an Expression Pedal here for control of MIDI parameters

Microphone Inputs - You can receive input from one or two mics at the same time using these ins. There is also a +48V Phantom Power switch that you should toggle to “on” if your mic requires phantom power (most condenser type mics do, but check the documentation for your mic if you are not sure). Connect each mic using an XLR cable. This inputs each microphone signal independently into GearBox where you can choose your tone, and then route the processed signal both to your audio software and out the TonePort outputs.

Guitar/Bass Input -To connect your electric guitar or bass, plug it into this input. This connection routes the instrument’s signal into GearBox where you can choose your tone and route the processed signal both to your audio software and out the TonePort outputs. This input also features a Pad switch; engage this switch when using a guitar/bass with high-output or active pickups, to avoid overdriving the input.

Headphones - If you want to listen to the audio from TonePort using stereo headphones, then plug them into this 1/4-inch stereo jack. This Headphone jack outputs the same signal fed to the Analog Outs on the rear panel of TonePort; the audio from your audio software on the computer, as well as anything plugged into any TonePort input.

Line Inputs - if you want to record the signal from a line level source, such as a keyboard, your stereo receiver, the line out from a mixing console, etc., connect them to these Left and Right ins using 1/4- inch TS audio cables.

Footswitches - if you want to use one or two on/off toggle or momentary footswitches to remotely control functions in the GearBox software, you can plug the 1/4-inch footswitch plugs into these 1 and 2 jacks. To configure each Footswitch, go to the GearBox Preferences. You can also use these footswitches to trigger recording and playback commands within the included Ableton Live Lite 5 software!

2•11

Page 18
Image 18
Line 6 3.7 manual TonePort KB37