Line 6 manual Line 6 GearBox 3.7 Driver Panel & Recording

Line 6 GearBox 3.7 – Driver Panel & Recording

effects, and a fully unprocessed signal.

•Dual-Tone Source*: If you’ve selected one of the dual input configurations from the input menu, Record 3-4 will always carry the signal from the second audio source. When GearBox is running, these sends will carry the Tone 2 signal of a Dual-Tone configuration.

*Note: TonePort DI, GX and GuitarPort devices can only run in Single-Tone configuration.

POD X3 devices show a list of 5 Record Sends:

Note that the type of signal that is fed to each Send is configured on the POD X3’s on-board Outputs

-Studio/Direct Mix settings screen. Or, if GearBox is running, the Studio/Direct Mix Pan sliders and Mute buttons for Tone 1 and Tone 2 as well as the Send volume knob all affect the signal fed to Send 1-2. To put it another way, Send 1-2 is fed the same “Studio/Direct Mix” as your main outputs, which could be just a Tone 1, or some combination of Tone 1 & 2, depending on how you set the Studio/ Direct mix controls. Please refer to your POD X3 Pilot’s Handbook for details on the Output screen options and especially about POD X3’s unique Dual Tone operation.

POD X3 also offers a Monitor Level slider in this tab as well - you can use this to independently adjust your POD X3 hardware monitor signal while recording (independently of the Send signal level that is being recorded).

3•7