Line 6 GearBox 3.7 – GearBox Stand-Alone Application

For TonePort UX8 only – Tone 1 and Tone 2 route to Record Send 9-10 and Record Send 11-12 respectively.

In Dual -Tone mode, the Tone 1 & Tone 2 toggle buttons appear at the top left to allow you to show the Amp and FX configuration for the respective Tone path. Note that these other controls across the top of the dialog automatically adjust the currently displayed Tone’s settings. For example, here the “Inst. & Mic1” Source is selected, and the “Instrument” Source’s Tone path is selected. Several controls at the top now affect only the Instrument Tone. To adjust the Mic 1 Tone settings, you switch the Tone 1, 2 toggle button, and then adjust the controls independently.

Tone 1, 2 toggle buttons

Monitor controls affect the currently displayed

 

Source’s Tone

 

 

 

 

 

 

 

 

 

 

 

 

Selects a Tone preset for current Source’s Tone

Out To Hardware controls affect BOTH Tones

Note that the Send meters and control automatically change when toggling between Tone 1 and Tone 2 Sources as well.

The Send 1-2 controls are shown for Tone 1, and

Send 3-4 controls are shown for Tone 2

Operating GearBox in Dual-Tone mode can require some major processing power from your computer (not surprisingly, twice as much as a single Tone!) Each effect that is powered “on” will use some processing power – effects that are “off” do not use processing power.

Note that the Hum Reducer is for Instrument Input 1 only. Hum Reducer is not available for Mic, Line or Digital input.

MIDI Control

When using GearBox with TonePort and GuitarPort devices, GearBox offers options for remote control of its parameters. You can connect a 3rd party MIDI controller device to a MIDI port on your computer and set GearBox to receive MIDI Continuous Controller (CC) data from it.

GearBox is also capable of sending out MIDI CC data for the adjustment of the onscreen GearBox knobs and switches.

4•9

Page 79
Image 79
Line 6 3.7 manual Midi Control