Line 6 GearBox 3.7 – UsingYour Line 6 Hardware

PODxt PRO

Phones - Connect

Instrument Input -

your stereo

Connect your guitar

Headphones

or bass

Instrument input – Connect your electric guitar or bass here using a standard 1/4-inch TS instrument cable. PODxt Pro itself contains the processing power that turns your naked input signal into that roaring guitar Tone, which is then fed out the Analog and Digital Outs, as well as fed to the Record Send 1-2 digitally to your computer across the USB connection. When you are connected via USB to your computer, you can also launch GearBox and use it to alternatively load Tones stored on your hard disc, edit them on your screen, and make adjustments for output and Record Send levels.

Phones - If you want to listen to the audio using stereo headphones, then plug them into this 1/4-inch stereo jack. This Headphone jack outputs the same signal fed to the Analog Line Outs; the audio from your audio software on the computer, as well as anything plugged into the Instrument input.

Connect any Line-Level source you want to record to the Line Input

Unprocessed Instrument Out- When

USB - Connect to

using GearBox Plug-in, connect to

your computer

3rd-party audio recording interface

 

Analog Line Outs, Use either Unbalanced (¼ -inch) jacks or Balanced (XLR) jacks to connect to your powered speakers or mixer

Digital Input and Output – use the AES/EBU or S/PDIF type connections to connect to other digital gear that uses one of these formats

Line Input - if you want to record the signal from a line level source, such as a keyboard, your receiver, the line out from a mixing console, etc…, connect it to this input using a 1/4-inch TS audio cable.

Unprocessed Guitar Out - This connection allows you to send an unprocessed signal to your recording application, while monitoring the fully processed signal thru the main Outputs. Very handy if you’re using a 3rd party recording interface with your recording application and the GearBox plug-in. For more info, go to the ToneDirect™ Monitoring section of this Guide.

Note: Your PODxt Pro can also send an unprocessed signal thru its USB connector, as explained here.

2•28

Page 35
Image 35
Line 6 3.7 manual PODxt PRO