Line 6 3.7 manual TonePort UX8, Rear Panel Features, Balanced Outputs, Pdif Digital Audio

Line 6 GearBox 3.7 – UsingYour Line 6 Hardware

TonePort UX8

The TonePort UX8 is a multichannel recording interface designed for professional use, offering plenty of headroom, a wide dynamic range and an exceedingly low noise floor. Designed with high quality electrical components and a rugged exterior, the UX8 is built to provide many years of reliability.

Included with the UX8 is the GearBox Plug-In, providing all your tracks with same POD quality tone trusted by scores of platinum-selling musicians and recording engineers. In addition, the GearBox standalone application provides a virtual front end for professional tone processing.

Rear Panel Features

Balanced Outputs

TonePort UX8 provides 8 balanced analog outputs (4 stereo pairs). For the cleanest audio signal, use 1/4-inch TRS cables to connect directly to your powered speakers, mixer or power amp setup.

Note that you can use each output pair to provide different monitor mixes for musicians during a tracking session. You can set the input mix levels for each output pair using the Line 6 Audio-MIDI Devices application.

S/PDIF Digital Audio

To send or receive S/PDIF, connect a 75-Ohm coaxial cable to the UX8’s RCA jack and the external S/PDIF device. This is the best choice for connecting to digital recording devices, such as a DAT recorder. This S/PDIF output sends the same audio as Main Outs 1-2*. The digital signal is always sent at 24 bit.

2•6