Line 6 GearBox 3.7 – UsingYour Line 6 Hardware

Phones - If you want to listen to the audio from TonePort using stereo headphones, then plug them into this 1/4-inch stereo jack. This headphone jack outputs the same signal fed to the Analog Outs on the rear panel of TonePort; the audio from your audio software on the computer, as well as anything plugged into any TonePort input.

D.I. Out - This connection lets you record an unprocessed signal to your track, to which you can apply the GearBox Plug-In. If you use a 3rd-party audio interface, connect the D.I. to one of its analog inputs, and route that input to the track you’re recording into. For more information on using the GearBox Plug-In, see the GearBox Plug-in Chapter.

Analog Outputs - When using TonePort DI as an audio interface for your recording application, these outputs carry the Master stereo mix from your recording project. If you ‘re using a 3rd-party Audio Interface, these outputs supply the ToneDirect™ magic to your interface or mixer, when using the GearBox application alongside the plug-in. See the ToneDirect™ Monitoring section for more details.

2•14

Page 21
Image 21
Line 6 3.7 manual 214