Mitsubishi Electronics MR-J2S- A instruction manual SC5

5. PARAMETERS

Class No. Symbol

	73		SC5
	74		SC6
	75		SC7
parameters 2
Expansion		76	TL2
		77
		78
		79
		80
		81
		82
		83
		84

Name and function	Initial	Unit	Setting	Control
	value		range	mode
Internal speed command 5	300	r/min	0 to in-	S
Used to set speed 5 of internal speed commands.			stanta-
			neous
Internal speed limit 5			permi-	T
Used to set speed 5 of internal speed limits.			ssible
			speed
Internal speed command 6	500	r/min	0 to in-	S
Used to set speed 6 of internal speed commands.			stanta-
			neous
Internal speed limit 6			permi-	T
Used to set speed 6 of internal speed limits.			ssible
			speed
Internal speed command 7	800	r/min	0 to in-	S
Used to set speed 7 of internal speed commands.			stanta-
			neous
Internal speed limit 7			permi-	T
Used to set speed 7 of internal speed limits.			ssible
			speed
Internal torque limit 2	100	%	0	P S T
Set this parameter to limit servo motor-generated torque on the			to
assumption that the maximum torque is 100[%].			100
When 0 is set, torque is not produced.
When torque is output in analog monitor output, this set value is the
maximum output voltage ( 8V). (Refer to Section 3.4.1, (5))
For manufacturer setting	00
Must not be changed.	10000
	10
	10
	100
	100
	100
	0

5 - 24