Mitsubishi Electronics MR-J2S- A instruction manual Sep.,2000

Print data	*Manual number	Revision
Sep.,2000	SH(NA)030006-B	Section 10.2.2: Addition of description to AL.30
		Addition of Cause to AL.33
		Chapter 11: Changed to only outline dimensional drawing
		Section 11.2 (2): Addition
		Section 12.2 (1): Review of Note for Table 12.1
		Section 12.3: Correction of dynamic brake time constant graph
		Chapter 13: Deletion of MR-CPC98CBL3M communication cable
		Section 13.1.1 (4)(c): Review of outline drawing
		Section 13.1.2 (1): Deletion of MR-PWCNF power supply connector set
		Section 13.1.2 (1)1), 6): Change of encoder side connector models
		Section 13.1.2 (1)19), 20): Change of terminal models
		Section 13.1.2 (2)(a)2): Addition of description for fabrication
		Section 13.1.3: Addition of POINT
		Section 13.1.3 (4): Addition of cable length
		Change in connection diagram
		Section 13.2.1 (1): Addition of Note for recommended wires
		Section 13.2.8 (1): Addition of leakage current to recommended filter
		Section 14.1.2 (2): Deletion of MR-CPC98CBL3M communication cable
		Section 14.11.1 (6): Addition
		Section 14.11.2 (8): Addition
		Section 15.7: Addition of POINT
		Section 15.8.1 (1)(b): Change in b) Coordinates when zero address is changed
		to other than 0
		Section 15.8.2 (1)(b): Review of connection diagram
		Section 15.9: Change of display screen
		Section 15.10.1 (1): Deletion of Cause 5 of ABS checksum error