Schneider Electric 4000

63230-300-212 Chapter3—Operation

April 2001 Configuring the Circuit Monitor Using Th eS etup Menu

Toset up a newly createdcustom alarm for use by the circuitmonitor, use the

Edit Parametersoption on the Alarm screen. You can alsochange

parametersof any alarm, new or existing. For example,using the Edit option

youcan enable or disable an alarm, changeits priority, and changeits pickup

and dropout setpoints.

Followthese instructions to set up or edit an alarm:

1. From the Main Menu, select Setup > Alarm > Edit Parameters.

The Edit Parametersscreen displays.

2. Select the Alarm Group:

•Standard

•High Speed

•Disturbance

•Digital

•Boolean

The Select Alarm screen displays.

NOTE: Ifyou are setting up or editing a digital alarm, alarm names suchas Breaker 1 trip,Breaker 1 reset will display instead.

3. Select the alarm you want to set up or edit.

The Edit Alarm screen with the alarm parametersdisplays. Table3–5

describes the optionson this menu.

Setting Up andEditing Alarms

EDIT PARAMETERS

Standard 1 sec

High Speed 100ms

Disturbance <1cycle

Digital

Boolean

SELECT ALARM

*01 Over Ia

02 Over Ib

03 Over Ic

EDIT ALARM

Lbl:Over Ia

Enable No

Priority None

Setpoint Mode Abs

Pickup 0

PU Dly seconds 0

Dropout 0

DO Dly seconds 0