63230-300-212

Chapter 3—Operation

April 2001

Performing a Wiring Check

 

 

PERFORMING A WIRING ERROR TEST

MAIN MENU

Meters

Min/Max

View Alarms

I/O Display

Resets

Setup

Diagnostics

If you are viewing a metered value, such as voltage, the circuit monitor updates the displayed value as the register contents change. Note that scale factors are not taken into account automatically when viewing register contents.

4.To scroll through the register numbers, use the arrow buttons.

5.To change the value in the register, press the enter button.

The Hex and Dec values begin to blink. Use the arrow buttons to scroll through the numeric values available.

NOTE: Some circuit monitor registers are read/write, some are read only. You can write to read/write registers only.

6.When you are finished making changes to that register, press the enter button to continue to the next register or press the menu button to save the changes.

The circuit monitor has the ability to perform a wiring diagnostic self-check when you select the Diagnostic > Wiring Error Test from the Main Menu as shown in Figure 3–10.

DIAGNOSTICS

Meter Information

CVM Information

Read/Write Regs

Wiring Error Test

Figure 3–10: Wiring Error Test option on the Diagnostics menu.

The circuit monitor can diagnose possible wiring errors when you initiate the wiring test on the Diagnostics menu. Running the test is not required, but may help you to pinpoint a potentially miswired connection. Before running the wiring test, you must first wire the circuit monitor and perform the minimum set up of the circuit monitor, which includes setting up these parameters:

CT primary and secondary

PT primary and secondary

System type

Frequency

After you have wired and completed the minimum set up, run the wiring test to verify proper wiring of your circuit monitor. The wiring test assumes that the following is true about your system:

© 2001 Schneider Electric All Rights Reserved

45

Page 57
Image 57
Schneider Electric 4000 manual Performing a Wiring Error Test, Wiring Error Test option on the Diagnostics menu