Schneider Electric 4000 manual 163

63230-300-212	Appendix A—Abbreviated Register Listing
April 2001	Register Listing

Table A–3:Abbreviated Register List

Register		Description	Scale	Units	Register Range
Number			Factor
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 02
3352		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 02.
		0 = none, default = 5 (Dig In A-S3)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 03
3353		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 03.
		0 = none, default = 6 (Dig In A-S4)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 04
3354		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 04.
		0 = none, default = 19 (Dig In B-S1)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 05
3355		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 05.
		0 = none, default = 20 (Dig In B-S2)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 06
3356		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 06.
		0 = none, default = 21 (Dig In B-S3)
		me
3357		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 07.
		0 = none, default = 22 (Dig In B-S4)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 08
3358		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 08.
		0 = none, default = 35 (Dig In C1)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 09
3359		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
		Status Bitmap: Bit 09.
		0 = none, default = 36 (Dig In C5)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 10
3360		IO Point Number for Discrete Input to include in Discrete Input	—	—	0 to 66
	￿	Status Bitmap: Bit 10.
		0 = none, default = 37 (Dig In C3)

See “How Power Factor is Stored in the Register” on page 128.

The alternate storage method for power factor (PF) is useful for outputting PF on analog outputs. The PF value is stored as a positive value between 0 and 2, centered around 1 (unity). A value of 0 lagging maps to 0; -0.999 maps to 0.999;0.999 leading maps to 1.001; and 0 leading maps to 2. The alternate PF is also stored with a scale factor 0.001.

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions on

￿how to use the setup-mode commands.

Quantity available for 4-wire system only. Value set to -32,768 if not available.

© 2001 Schneider Electric All Rights Reserved 163