Schneider Electric 4000 manual Kwh

Appendix A—Abbreviated Register Listing	63230-300-212
Register Listing	April 2001

Table A–4:Abbreviated Register List for I/O Status

Register	Name	Units	Range		Description
Number
				IO Point Type to digital Output
				First digit (2) indicates point is digital output.
				Second digit indicates module type
				0	= Generic digital output
Base	IO Point Type	—	200 to 299	1 = DO120AC Pluggable Module
				2	= DO200DC Pluggable Module
				3	= DO240AC Pluggable Module
				4	= DO60DC Pluggable Module Third digit indicates output type
				1	= solid state relay
				2	= electromechanical relay
Base + 1	IO Point Label	Alpha-	—	16-character label
		Numeric
				digital Output Operating Mode
				0	= Normal (default)
				1	= Latched
				2	= Timed
				3	= Absolute kWh pulse
				4	= Absolute kVARh pulse
Base + 9￿	Mode	—	0 to 11	5 = kVAh pulse
				6	= kWh In pulse
				7	= kVARh In pulse
				8	= kWh out pulse
				9	= kVARh out pulse
				10 = Register-based pulse (future)
				11 = End of power demand interval
Base + 10	On Time For Timed	Seconds	1 to 32,767	The time for the output to remain energized when the output is in
	Mode			timed mode or end of power demand interval. (Default = 1)
￿
		KWH/
		Pulse
		kVarH/		Specifies the kWh, kVARh and kVAh per pulse for output when in
Base + 11	Pulse Weight	Pulse	1 to 32,767
				these modes. (Default = 1)
		kVAH/
		Pulse in
		100ths
	Internal/External			Indicates active output state.
Base + 12		—	0 to 1	0 = Internal Control
	Control
				1	= External Control (default)
	ControlNormal/Override			Indicates active output state.
Base + 13￿		—	0 to 1	0 = Normal Control (default)
				1	= Override Control
				IO Point Diagnostic Bitmap:
				0	= OK, 1 = Error
				Bit 00 = IO Point diagnostic summary
				Bit 01 = Configuration invalid to default value used
Base + 22	IO Point Diagnostic	—	0x0000 to	Bit 02 = digital output energy pulse to time between transitions
	Bitmap		0x000F	exceeds 30 seconds
				Bit 03 = digital output energy pulse to time between transitions
				limited to 20 milliseconds
				Remaining bits not used.
Base + 25	Digital Output On/Off	—	0 to 1	digital output Off/On status: 0 = Off, 1 = On
	Status

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup

￿￿mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions

on how to use the setup-mode commands.© 2001 Schneider Electric All Rights Reserved170