Schneider Electric 4000 manual 164

Appendix A—Abbreviated Register Listing	63230-300-212
Register Listing	April 2001

Table A–3:Abbreviated Register List

Register		Description		Scale	Units	Register Range
Number				Factor
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 11
3361		IO Point Number for Discrete Input to include in Discrete Input		—	—	0 to 66
		Status Bitmap: Bit 11.
		0 = none, default = 38 (Dig In C4)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 12
3362		IO Point Number for Discrete Input to include in Discrete Input		—	—	0 to 66
		Status Bitmap: Bit 12.
		0 = none, default = 39 (Dig In C5)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 13
3363		IO Point Number for Discrete Input to include in Discrete Input		—	—	0 to 66
		Status Bitmap: Bit 13.
		0 = none, default = 40 (Dig In C6)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 14
3364		IO Point Number for Discrete Input to include in Discrete Input		—	—	0 to 66
		Status Bitmap: Bit 14.
		0 = none, default = 41 (Dig In C7)
		Discrete Input Point Assignment to Discrete Input Status
		Bitmap Bit 15
3365		IO Point Number for Discrete Input to include in Discrete Input		—	—	0 to 66
		Status Bitmap: Bit 15.
		0 = none, default = 42 (Dig In C8)
Communication
		RS-485 Comm Port #1 Operation Mode
3400		0	= Modbus Slave (default)	—	—	0 to 1
		1	= Jbus Slave
		RS-485 Comm Port #1 Address
3401		Valid Addresses: (Default = 1)		—	—	0 to 255
		Modbus: 0 to 247
		Jbus: 0 to 255
		RS-485 Comm Port #1 Baud Rate
		0	= 1200
		1	= 2400
3402		2	= 4800	—	—	0 to 5
		3	= 9600 (default)
		4	= 19200
		5	= 38400
		RS-485 Comm Port #1 Parity
3403		0	= Even (default)	—	—	0 to 2
		1	= Odd
	￿	2 = None
		RS-485 Comm Port #2 Operation Mode
3430		0	= Modbus Slave (default)	—	—	0 to 1
		1	= Jbus Slave

See “How Power Factor is Stored in the Register” on page 128.

The alternate storage method for power factor (PF) is useful for outputting PF on analog outputs. The PF value is stored as a positive value between 0 and 2, centered around 1 (unity). A value of 0 lagging maps to 0; -0.999 maps to 0.999;0.999 leading maps to 1.001; and 0 leading maps to 2. The alternate PF is also stored with a scale factor 0.001.

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions on

￿how to use the setup-mode commands.

Quantity available for 4-wire system only. Value set to -32,768 if not available.

164 © 2001 Schneider Electric All Rights Reserved