Schneider Electric 4000 manual Digital Input Template

168￿￿

Appendix A—Abbreviated Register Listing	63230-300-212
Register Listing	April 2001

Table A–4:Abbreviated Register List for I/O Status

Register		Name	Units	Range	Description
Number
4930–4959		IO Point Number 22			Register contents depend on IO Point Type. Refer to templates
		(B04)			below.
4960–4989		IO Point Number 23			Register contents depend on IO Point Type. Refer to templates
		(B05)			below.
4990–5019		IO Point Number 24			Register contents depend on IO Point Type. Refer to templates
		(B06)			below.
5020–5049		IO Point Number 25			Register contents depend on IO Point Type. Refer to templates
		(B07)			below.
5050–5079		IO Point Number 26			Register contents depend on IO Point Type. Refer to templates
		(B08)			below.
5320–5349		IO Point Number 35			Register contents depend on IO Point Type. Refer to templates
		(C01)			below.
5350–5379		IO Point Number 36			Register contents depend on IO Point Type. Refer to templates
		(C02)			below.
5380–5409		IO Point Number 37			Register contents depend on IO Point Type. Refer to templates
		(C03)			below.
5410–5439		IO Point Number 38			Register contents depend on IO Point Type. Refer to templates
		(C04)			below.
5440–5469		IO Point Number 39			Register contents depend on IO Point Type. Refer to templates
		(C05)			below.
5470–5499		IO Point Number 40			Register contents depend on IO Point Type. Refer to templates
		(C06)			below.
5500–5529		IO Point Number 41			Register contents depend on IO Point Type. Refer to templates
		(C07)			below.
5530–5559		IO Point Number 42			Register contents depend on IO Point Type. Refer to templates
		(C08)			below.
Digital Input Template
					First digit (1) indicates point is digital input.
					Second digit indicates module type
					0 = Generic digital input
					1 = DI120AC Pluggable Module
Base		IO Point Type	—	100 to 199	2 = DI240AC Pluggable Module
					3 = DI32DC Pluggable Module
					Third digit indicates input type
					1 = AC
					2 = DC
Base + 1		IO Point Label	Alpha-	—	16-character label
			Numeric
					digital Input Operating Mode
					0 = Normal (default)
					1 = Demand Interval Sync Pulse
					2 = Time Sync
					3 = Conditional Energy Control
Base + 9		Mode	—	0 to 3	Only one Time Sync input and one Conditional Energy Control are
￿
					allowed. If the user attempts to configure more than one of each of
					these modes, the lowest IO Point Number will take precedence. The
					modes of the other points will be set to default. Time sync input
					signal must be pulse duration method (PDM) as from the Modicon
					GPS Receiver (470 GPS 001 00).
	￿

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions on how to use the setup-mode commands.

© 2001 Schneider Electric All Rights Reserved