Schneider Electric 4000 manual 167

63230-300-212	Appendix A—Abbreviated Register Listing
April 2001	Register Listing

Table A–4:Abbreviated Register List for I/O Status

Register	Name	Units	Range	Description
Number
				Bitmap of Time Sync Signal Health Status:
				0 = OK, 1 = Error
				Bit 00 = Summary Bit , time sync signal fatal error
	Time Sync Signal		0x0000 to	Bit 01 = Lost time sync signal
4016		—		Bit 02 = Summary Bit , invalid data
	Health Status		0xFFFF
				Bit 12 = Good time sync signal received
				Bit 13 = Reserve antenna in use
				Bit 14 = DST warning
				Bit 15 = DST in effect
4017	GPS Time Sync	milli-	0 to 1,000	GPS Time Sync Accuracy
	Accuracy	seconds
				Indicates the type of Option Module present in Option Slot A.
4021	Present Module Type	—	0 to 7	0 = Not Installed
	Option Slot A			1 = IOC44
				6 = Ethernet Option Module
				Indicates the type of Option Module present in Option Slot B.
4022	Present Module Type	—	0 to 7	0 = Not Installed
	Option Slot B			1 = IOC44
				6 = Ethernet Option Module
	Present Module Type			Indicates the presence of the pluggable IO rack.
4023		—	0, 5	0 = No module present
	Pluggable IO
				5 = Pluggable IO rack present
4200–4299	Digital Output/Alarm	—	0 to 17081	Table of digital output/alarm associations. Upper byte is IO Point
	Table			Number (1 to 66). Lower byte is Alarm Index Number (1 to 185).
	IO Point Number 1
4300–4329	Standard Digital			Refer to digital Output template below.
	Output (KYZ)
4360–4389	IO Point Number 3			Register contents depend on IO Point Type. Refer to templates
	(A01)			below.
4390–4419	IO Point Number 4			Register contents depend on IO Point Type. Refer to templates
	(A02)			below.
4420–4449	IO Point Number 5			Register contents depend on IO Point Type. Refer to templates
	(A03)			below.
4450–4479	IO Point Number 6			Register contents depend on IO Point Type. Refer to templates
	(A04)			below.
4480–4509	IO Point Number 7			Register contents depend on IO Point Type. Refer to templates
	(A05)			below.
4510–4539	IO Point Number 8			Register contents depend on IO Point Type. Refer to templates
	(A06)			below.
4540–4569	IO Point Number 9			Register contents depend on IO Point Type. Refer to templates
	(A07)			below.
4570–4599	IO Point Number 10			Register contents depend on IO Point Type. Refer to templates
	(A08)			below.
4840–4869 ￿	IO Point Number 19			Register contents depend on IO Point Type. Refer to templates
	(B01)			below.
4870–4899	IO Point Number 20			Register contents depend on IO Point Type. Refer to templates
	(B02)			below.
4900–4929	IO Point Number 21			Register contents depend on IO Point Type. Refer to templates
	(B03)			below.

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup

￿￿	mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions
	on how to use the setup-mode commands.
© 2001 Schneider Electric All Rights Reserved		167