Schneider Electric 4000 manual Metering Configuration, 159

63230-300-212	Appendix A—Abbreviated Register Listing
April 2001	Register Listing

Table A–3:Abbreviated Register List

Register	Description	Scale	Units	Register Range
Number		Factor
Metering Configuration
	Metering System Type
	System Connection
	30 = 3PH3W2CT
3200	31 = 3PH3W3CT	—	—	30,31, 40,41,42,43
	40 = 3PH4W3CT (default)
	41 = 3PH4W4CT
	42 = 3PH4W3CT2PT
	43 = 3PH4W4CT2PT
3201	CT Ratio, Phase Primary	—	Amps	1 to 32,767, Default = 5
3202	CT Ratio, Phase Secondary	—	Amps	1, 5, Default = 5
3203	CT Ratio, Neutral Primary	—	Amps	1 to 32,767, Default = 5
3204	CT Ratio, Neutral Secondary	—	Amps	1, 5, Default = 5
3205	PT Ratio, Phase Primary	—	Volts/Scale	1 to 32,767, Default = 120
3206	PT Ratio, Phase Primary Scale Factor	—	—	-1 to 2, Default = 0
	-1 = Direct Connect
3207	PT Ratio, Phase Secondary	—	Volts	100, 110, 115, 120;
				Default = 120
3208	Nominal System Frequency	—	Hertz	50,60,400; Default = 60
3209	Scale A to Phase Amps	—	—	-2 to 1, Default = 0
3210	Scale B to Neutral Amps	—	—	-2 to 1, Default = 0
3211	Scale C to Ground Amps	—	—	-2 to 1, Default = 0
3212	Scale D to Phase Volts	—	—	-1 to 2, Default = 0
3213	Scale E to Neutral Volts	—	—	-1 to 2, Default = -1
3214	Scale F to Power	—	—	-3 to 3, Default = 0
3216 ￿	Scale H to Transient Voltages	—	—	0 to 3, Default = 1

See “How Power Factor is Stored in the Register” on page 128.

The alternate storage method for power factor (PF) is useful for outputting PF on analog outputs. The PF value is stored as a positive value between 0 and 2, centered around 1 (unity). A value of 0 lagging maps to 0; -0.999 maps to 0.999;0.999 leading maps to 1.001; and 0 leading maps to 2. The alternate PF is also stored with a scale factor 0.001.

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions on

￿how to use the setup-mode commands.

Quantity available for 4-wire system only. Value set to -32,768 if not available.

© 2001 Schneider Electric All Rights Reserved 159