Schneider Electric 4000 manual 155

63230-300-212	Appendix A—Abbreviated Register Listing
April 2001	Register Listing

Table A–3:Abbreviated Register List

Register	Description	Scale	Units	Register Range
Number		Factor
2420 to 2439	Generic Channel #2
	Same as registers 2400 to 2419 except for Channel #2
2440 to 2459	Generic Channel #3
	Same as registers 2400 to 2419 except for Channel #3
2460 to 2479	Generic Channel #4
	Same as registers 2400 to 2419 except for Channel #4
2480 to 2499	Generic Channel #5
	Same as registers 2400 to 2419 except for Channel #5
2500 to 2519	Generic Channel #6
	Same as registers 2400 to 2419 except for Channel #6
2520 to 2539	Generic Channel #7
	Same as registers 2400 to 2419 except for Channel #7
2540 to 2559	Generic Channel #8
	Same as registers 2400 to 2419 except for Channel #8
2560 to 2579	Generic Channel #9
	Same as registers 2400 to 2419 except for Channel #9
2580 to 2599	Generic Channel #10
	Same as registers 2400 to 2419 except for Channel #10
2600 to 2619	Generic Channel #11
	Same as registers 2400 to 2419 except for Channel #11

See “How Power Factor is Stored in the Register” on page 128.

The alternate storage method for power factor (PF) is useful for outputting PF on analog outputs. The PF value is stored as a positive value between 0 and 2, centered around 1 (unity). A value of 0 lagging maps to 0; -0.999 maps to 0.999;0.999 leading maps to 1.001; and 0 leading maps to 2. The alternate PF is also stored with a scale factor 0.001.

These configuration registers require that you enter the setup mode to change the register’s contents. Issue command 9020 to enter setup mode and 9021 to exit setup mode. See “Using the Command Interface to Change Configuration Registers” on page 187 for instructions on

￿how to use the setup-mode commands.

Quantity available for 4-wire system only. Value set to -32,768 if not available.

© 2001 Schneider Electric All Rights Reserved 155