Siemens MC55 manual Cellnum, BSICnum, Channnum

MC55 AT Command Set

8.5 AT^SMONC

s

mobile

<LAC>(num) Location area code

4 digits, e.g. 3010
0000	not decoded
<cell>(num)
Cell identifier

4 hexadecimal digits, e.g. 4EAF

0000 not decoded

<BSIC>(num)

Base station identity code 2 digits, e.g. 32

00not decoded

<chann>(num)

ARFCN (Absolute Frequency Channel Number)

0	not decoded. In this case, all remaining parameters related to the same chan-
	nel are neither decoded. For example, a non-existing cell appears as follows:
	000,000,0000,0000,00,0,0,-,-

<RSSI>(num)

Received signal level of the BCCH carrier (0..63). The indicated value is composed of the measured value in dBm plus an offset. This is in accordance with a formula specified in 3GPP TS 05.08

<C1>(num)

Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter can- not be updated. In such cases a '-' is presented.

<C2>(num)

Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter can- not be updated. In such cases a '-' is presented.

Note

•To some extent, the cell monitoring commands AT^MONI, AT^MONP and AT^SMONC cover the same param- eters. The receiving level, for example, can be queried with all three commands. Yet the resulting values may be slightly different, even though obtained over a time period of a few seconds. This is quite normal and noth- ing to worry about, as the cell information is permanently updated.

MC55_ATC_V01.05	Page 196 of 469	2/10/04
Confidential / Released