Siemens MC55 Atsmong Cell Info Table, Gprs Monitor, Bcch Pbcch PAT MCC MNC NOM RAC, # Cell #

MC55 AT Command Set

8.8 AT^SMONG

<period>(num)

s

mobile

Display period in seconds

If <period> is omitted the cell data will be presented only once on a single line (as if Execute command was issued).

If <period> is given, the cell data will be listed repeatedly on 10 data lines. Every 10th data line is followed by the header, simply to repeat the column titles.

1...100

Note

•For compatibility with earlier products and to support legacy applications, often any input character will stop the periodic output of the write command. But since this applies only in certain cases (depending on the set- tings of Chapter 4.7, page 96 and Chapter 4.8, page 99), it is recommended to always use "at" or "AT".

8.8.1AT^SMONG Cell Info Table

Example output for AT^SMONG:

GPRS Monitor
BCCH	G	PBCCH	PAT MCC	MNC	NOM	TA	RAC	# Cell #
0637	1	-	4 234	05	2	00	0B

Columns of the cell info table:

Column	Description
BCCH	ARFCN of BCCH carrier
G	GPRS supported (''1'') or not supported ''-''
PBCCH	If PBCCH is present, indication of ARFCN, else ''-'' or if Frequency Hopping is used ''H''
PAT	Priority Access Threshold (GSM Rec. 04.08 / 10.5.2.37b)
	0	Packet access is not allowed in the cell
	1	Spare, shall be interpreted as "000" (packet access not allowed)
	2	Spare, shall be interpreted as "000" (packet access not allowed)
	3	Packet access is allowed for priority level 1
	4	Packet access is allowed for priority level 1 to 2
MCC	Mobile Country Code
MNC	Mobile Network Code
NOM	Network Operation Mode (1...3)
TA	Timing Advance Value
RAC	Routing Area Code (as hexadecimal value)

MC55_ATC_V01.05	Page 204 of 469	2/10/04
Confidential / Released