MC55 AT Command Set
8.7 AT^MONP s
m
obil
e
MC55_ATC_V01.05 Page 202 of 469 2/10/04
Confidential / Released
there are several constraints to be considered:
- Only neighbour cells that have already been visible in IDLE mod e will be further updated, as long as they
are still included in the list.
- Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.
- To some extent, the cell monitoring command AT^SMONC covers the same parameters. The receiv ing
level, for example, can be queried with both commands. Yet the resul ting values may be slightly different,
even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about,
as the cell information is permanently updated.
- For compatibility with earlier products and to support legacy ap plications, any input character may be used
to stop the output in certain cases (depending on the settings of Chapter 4.7, page 96 and Chapter 4.8,
page 99).
8.7.1 AT^MONP responses
Response of AT^MONP (Example):
chann rs dBm MCC MNC BCC C1 C2
653 26 -84 262 07 0 22 22
660 20 -90 262 07 3 16 16
687 19 -91 262 07 1 15 15
678 14 -96 262 07 3 10 10
671 14 -96 262 07 1 10 10
643 10 -100 262 07 7 6 6
Column Description
Chann ARFCN (Absolute Radio Frequency Channel Number) of the BCCH carrier
rs RSSI value 0 - 63 (RSSI = Received signal strength indication)
dBm Receiving level in dBm
MCC Mobile Country Code (first part of the PLMN code)
MNC Mobile Network Code (second part of the PLMN code)
BCC Base Station colour code
C1 cell selection criterion
C2 cell reselection criterion