Siemens MC55 manual Used2num, Used3num, Total1num, Total2num, Total3num

MC55 AT Command Set

12.12 AT+CPMS

s

mobile

<used2>(num)

Number of messages currently in <mem2>

<used3>(num)

Number of messages currently in <mem3>

<total1>(num)

Number of messages storable in <mem1>

<total2>(num)

Number of messages storable in <mem2>

<total3>(num)

Number of messages storable in <mem3>

Notes

•The Mobile Equipment storage ''ME'' offers space for 25 short messages, see <mem1>.

•''MT'' is the sum of ''ME'' (= 25 locations) and ''SM'' (capacity varies with SIM card). The indices <index> of the ''MT'' storage are dependent on the order selected with AT^SSMSS

•The <mem1>, <mem2> and <mem3> parameter will be stored in non-volatile memory.

•The user should be aware that the setting ''MT'' involves ''ME'' and ''SM'', with ''ME'' being filled up first. If the ''ME'' storage is full, MC55 will proceed with the ''SM'' storage.

Incoming Class 1 short messages (ME specific) will be preferably stored to ''ME'' and may be transferred to the ''SM'' storage if ''ME'' is used up.

Incoming Class 2 messages (SIM specific) will be stored to the SIM card only, no matter whether or not there is free ''ME'' space. As a result, the ^SMGO: 2 indication (see AT^SMGO) may be presented without prior indi- cation of ^SMGO: 1. For more information regarding SIM and ME specific message classes refer to <dcs> and the following specifications: GSM 03.38 and 3GPP TS23038.

•When <mem3> is switched over from ''MT'' to ''SM'' all free ''ME'' locations will be filled with dummy short mes- sages. This procedure can take up to 35 seconds, until all the 25 records are written.

If switching from ''MT'' to ''SM'' was not finished due to error or user break, the value of <mem3> remains ''MT'', but some of the dummy records remain in the ''ME'' storage. These records have to be deleted manually. When <mem3> equals ''SM'', do not delete the dummy messages in the ''ME''. storage. They will be automat- ically deleted when you switch back from ''SM'' to ''MT''. Again, this may take up to 35 seconds.

If switching from ''SM'' to ''MT'' was not finished due to an error or user break, the value of <mem3> remains ''SM'', but the ''ME'' storage will no longer be filled with dummy records. New incoming short messages may now be written to the ''ME'' storage, if ''SM'' is already full. To avoid this, repeat the AT+CPMS command as soon as possible to switch <mem3> back to ''MT''. As an alternative, you can manually delete the dummy records and issue AT+CPMS=MT,MT,MT.

•Multiplexer: In Multiplex mode or when the two physical serial interfaces are connected, the parameter <mem3> will be the same on all instances, but the settings of <mem1> and <mem2> may vary on each channel / interface. As a result, changes on parameter <mem1> and/or <mem2> befor activating the multiplexer or dif- ferences values for other instanes can result in not desired behaviours like different outputs for AT+CMGL and so on.

•While <mem3> equals ''SM'' and <mem1> equals ''ME'' it is possible that, after deleting short messages from ''ME'', the freed space on ''ME'' is reclaimed for new incoming short messages, when there is no space left on the ''SM'' storage. As it is often the clients concern to have received short messages stored only to the SIM

MC55_ATC_V01.05	Page 335 of 469	2/10/04
Confidential / Released