MC55 AT Command Set

10.9 AT+CGQREQ

s

mobile

10.9AT+CGQREQ Quality of Service Profile (Requested)

Syntax

Test Command

AT+CGQREQ=?

Response(s)

+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list of supported <delay>s), (list of supported <reliability>s), (list of supported <peak>s), (list of supported <mean>s)

OK

Read Command

AT+CGQREQ?

Response(s)

+CGQREQ: <cid>, <precedence>, <delay>, <reliability>, <peak>, <mean>

[+CGQREQ: <cid>, <precedence>, <delay>, <reliability>, <peak>, <mean>]

...

Write Command

AT+CGQREQ=[<cid>[, <precedence>[, <delay>[, <reliability>[, <peak>[, <mean>]]]]]]

Response(s)

OK ERROR +CME ERROR

PIN ASC0 ASC1 MUX1 MUX2 MUX3

￿ ￿ ￿ ￿ ￿ ￿

Reference(s)

GSM 07.07

Command Description

The test command returns values supported as a compound value. If the MT supports several PDP types, the parameter value ranges for each PDP type are returned on a separate line.

The read command returns the current settings for each defined context. If no requested profile was explicitly specified for a context, simply OK will be returned, but default values will be used for that context.

This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate PDP Context Request message to the network.

The set command specifies a profile for the context identified by the (local) context identification parameter, <cid>.

A special form of the set command, +CGQREQ=<cid> causes the requested profile for context number <cid> to become undefined.

MC55_ATC_V01.05

Page 260 of 469

2/10/04

Confidential / Released

 

 

Page 260
Image 260
Siemens MC55 manual 10.9 AT+CGQREQ Quality of Service Profile Requested, At+Cgqreq=?, At+Cgqreq?