Siemens MC55 manual Status Control Commands, AT+CMER Mobile Equipment Event Reporting, At+Cmer=?

MC55 AT Command Set

3. Status Control Commands

s

mobile

3.Status Control Commands

The AT Commands described in this chapter allow the external application to obtain various status information from the MC55.

3.1AT+CMER Mobile Equipment Event Reporting

This command controls details of the "+CIEV" URC presentation related to AT^SIND and AT+CIND. If registered via these commands the URCs are sent whenever a value of the related indicator changes.

In addition, AT+CMER controls "^SLCC" URCs related to AT^SLCC. For details refer to Call Status Infor- mation, AT^SLCC and AT^SCFG, parameter <sucs>. After AT+CMER has been switched on, URCs for all reg- istered indicators will be issued.

Syntax

Test Command

AT+CMER=?

Response(s)

+CMER: (list of supported<mode>s), (list of supported <keyp>s), (list of supported <disp>s), (list of supported <ind>s), (list of supported <bfr>s)

OK

Read Command

AT+CMER?

Response(s)

+CMER: <mode>, <keyp>, <disp>, <ind>, <bfr>

OK

Write Command

AT+CMER=[<mode>[, <keyp>[, <disp>[, <ind>[, <bfr>]]]]]

Response(s)

OK ERROR +CME ERROR

PIN ASC0 ASC1 MUX1 MUX2 MUX3

￿ ￿ ￿ ￿ ￿ ￿

Reference(s)

GSM 07.07

MC55_ATC_V01.05	Page 63 of 469	2/10/04
Confidential / Released