MC55 AT Command Set
9.6 AT+CCFC s
m
obil
e
MC55_ATC_V01.05 Page 223 of 469 2/10/04
Confidential / Released
3 not reachable
4 all call forwarding (includes reasons 0, 1, 2 and 3)
5 all conditional call forwarding (includes reasons 1, 2 and 3)
network operation to be performed for Supplementary service "call fo rwarding"
0 disable call forwarding (disable service)
1 enable call forwarding (enable service)
2 query status of call forwarding (query service status)
3 register <number> and activate call forwarding (register service)
4erase
<number> and deactivate call forwarding (erase service)
string type phone number of forwarding address in format specified by <type>. If you select <mode>= 3, the
phone <number> will be registered in the network. This allows you to disable / enable CF to the sa me destination
without the need to enter the phone number once again. Depending on the services offe red by the provider the
registration may be mandatory before CF can be used. The number remains registered in the network until you
register another number or erase it using <mode> = 4.
type of address octect
145 dialling string <number> includes international access code charact er '+'
129 otherwise
integer or sum of integers each representing a class of information, i.e. a bearer service, telecommuni cation ser-
vice or bearer service group as defined in "GSM 02.04"
1voice
2 data
<class> 2 (data) comprises all those <class> values between 16 and 128, that
are supported both by the network and the MS. This means, a setting made for
<class> 2 applies to all remaining data classes (if supported). In addition, you
can assign a different setting to a specific class. For example, yo u can activate
Call Forwarding for all data classes, but deactivate it for a specific data class.
4fax
8SMS
16 data circuit sync
32 data circuit async
64 dedicated packet access
128 dedicated PAD access
1...[7]...255 combination of some of the above classes. For example, the default setting 7
represents the sum of the integers 1, 2 and 4 (CF for voice, data and fax). The
value 255 covers all classes. If the <class> parameter is omitted, the de fault
value 7 is used.
<mode>(num)
<number>(str)
<type>(num)
<class>(num)