Siemens MC55 manual Serial Interface Control Commands, AT\Q Flowcontrol, AT\Qn, Error

MC55 AT Command Set

4. Serial Interface Control Commands

s

mobile

4.Serial Interface Control Commands

The AT Commands described in this chapter allow the external application to determine various settings related to the MC55's serial interface.

4.1AT\Q Flowcontrol

Syntax

Exec Command

AT\Q[<n>]

Response(s)

OK

If RTS/CTS flow control is not supported by interface and <n> is 2 or 3:

ERROR

PIN	ASC0	ASC1	MUX1	MUX2	MUX3
￿	￿	￿	￿	￿	￿
Reference(s)
V.25ter

Parameter Description

<n>(num)(&W)(&V)

[0](&F)	disable flow control
1	XON/XOFF software flow control
2	only CTS by DCE
3	RTS/CTS hardware flow control
	Recommended for the following procedures: incoming or outgoing data calls,
	fax calls, MUX mode.
	Often, the initialization routine of Fax programs includes enabling RTS/CTS
	handshake, eliminating the need to issue AT\Q3 once again.

Notes

•When using XON/XOFF flow control (AT\Q1) in online mode, +++ should not be used while the data trans- mission is paused with XOFF. Before entering the command mode with +++ the paused transmission should be resumed using the XON character.

•For compatibility reasons, the AT\Q command can be used in Multiplex mode, though the settings will not take effect. However, be aware that whenever you use the AT\Q write command in Multiplex mode and then save the current configuration to the user profile with AT&W, the changed AT\Q setting will become active after restart.

MC55_ATC_V01.05	Page 89 of 469	2/10/04
Confidential / Released