Siemens MC55 manual Mobile

MC55 AT Command Set

8.6 AT^MONI

s

mobile

NCC and BCC. Until the information is received from the new base station, the default values will be shown instead: cell="0000", NCC="-", BCC="-".

•If the BS supports frequency hopping during a connection, the dedicated channel (parameter chann) is not stable. This mode is indicated by chann = 'h'.

•To some extent, the cell monitoring command AT^SMONC covers the same parameters. The receiving level, for example, can be queried with both commands. Yet the resulting values may be slightly different, even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about, as the cell information is permanently updated.

•for compatibility with earlier products and to support legacy applications, any input character may be used to stop the output in certain cases (depending on the settings of Chapter 4.7, page 96 and Chapter 4.8, page 99).

MC55_ATC_V01.05	Page 200 of 469	2/10/04
Confidential / Released