MC55 AT Command Set

17.4 AT^SBV

s

mobile

17.4AT^SBV Battery/Supply Voltage

Syntax

Test Command

AT^SBV=?

Response(s)

OK ERROR +CME ERROR:

Exec Command

AT^SBV

Response(s)

^SBV: <value>

OK ERROR +CME ERROR:

PIN ASC0 ASC1 MUX1 MUX2 MUX3

￿ ￿ ￿ ￿ ￿ ￿

Reference(s)

SIEMENS

Command Description

The exec command allows to monitor the supply (or battery) voltage of the module measured on pin BATT+. The reference point for measuring the voltage are the test points BATT+ and GND on the bottom of the module. Refer to [1] for information on the module's test points.

The displayed value is constant over the measurement period. The duration of the measurement period depends on the operating mode on the radio interface: it ranges from 0.5s in TALK / DATA mode up to 50s when MC55 is in IDLE mode or Limited Service (deregistered).

Parameter Description

<value>(num)

supply (or battery) voltage in mV

MC55_ATC_V01.05

Page 433 of 469

2/10/04

Confidential / Released

 

 

Page 433
Image 433
Siemens MC55 manual Atsbv Battery/Supply Voltage, Atsbv=?, SBV value