Siemens MC55 manual ATS18 Extended call release report, ATS18?, ATS18=n, +CAUSE locationID, reason

MC55 AT Command Set

3.5 ATS18

s

mobile

3.5ATS18 Extended call release report

Syntax

Read Command

ATS18?

Response(s)

<n>

OK

Write Command

ATS18=<n>

Response(s)

OK

PIN ASC0 ASC1 MUX1 MUX2 MUX3

￿ ￿ ￿ ￿ ￿ ￿

Reference(s)

V.25ter

Command Description

This command enables or disables the presentation of extended call release reports for fax and data calls. The call release report is presented in numeric format and includes the following parameters:

+CAUSE: <locationID>, <reason>

If enabled the message will be reported every time a fax or data call is released or fails to be established.

Parameter Description

<n>(num)(&W)(&V)

An odd number enables the presentation of the extended call release report. An even number disables this fea- ture.

0(&F)...255

<locationID>(num)

Location ID as number code (see also <locationID> of AT+CEER). Location IDs are listed in section 3.4.1. Each ID is related to another table that contains a list of <reason>s.

<reason>(num)

Reason for last call release as number code (see also <reason> of AT+CEER). <reason> numbers and the associated descriptions are listed in several tables, sorted by different categories in Chapter AT+CEER. The tables can be found proceeding from the Location IDs listed in 3.4.1.

MC55_ATC_V01.05	Page 85 of 469	2/10/04
Confidential / Released