2 Product Overview

Ground Fault Interrupter (GFI)

If a fault is detected in the power supply to the machine, a Ground Fault Interrupter (GFI) device on the machine automatically cuts all electrical power. If power is interrupted, locate the RESET button on the back of the machine. If the GFI has been triggered, the RESET button will be in the tripped position. To restore power to the machine, press the RESET button.

Before using the machine, press the TEST button. If the GFI is working properly, the RESET button should pop up. If it does, press the RESET button.

TEST button

RESET button

NOTE: If the RESET button pops back up when you press it, or if power is not restored by this procedure, contact the Xerox Welcome Center.

Energy Saver Modes

The machine has a power saving feature that significantly reduces power consumption during periods of inactivity. The <Energy Saver> button is located on the upper-right portion of the control panel, and lights up when the power saving feature is enabled. The power saving feature operates in the following modes.

Low Power Mode

Sleep Mode

Low Power Mode

<Energy Saver>

light/button

The machine automatically switches to the Low Power Mode after a certain period of time from the last copy, fax, scan, or print operation. In this mode, the touch screen is turned off, and the <Energy Saver> light is on. The Low Power Mode is cancelled when the <Energy Saver> button on the control panel is pressed, or a fax or print job is received by the machine. The factory default setting of 10 minutes is customer changeable within the range of 2 to 60 minutes.

Sleep Mode

The machine automatically switches from the Low Power Mode to the Sleep Mode after a further period of inactivity. The Sleep Mode has a reduced power consumption compared to Low Power Mode. In this mode, the touch screen is turned off, and the

40

Page 40
Image 40
Xerox 5230 manual Ground Fault Interrupter GFI, Energy Saver Modes, Low Power Mode, Sleep Mode