ADTRAN 25 manual Connect Tie Trunks

INSTALLATION

Connect Tie Trunks

A 2:1 connectorized splitter cable, WP90929, L3, is required to connect the 700A Jack to the cabinet for tie trunks.

1.Install secondary protectors (see Table 2-B).

2.Using the cable label sheets provided (Figure 2-7),label the back of the hood of each of the connectors (1 and 2) on the two legs of the splitter cable. Use an appropriate cabinet and slot number label (CAB 1 SLOT8, for example).

3.On connector O, install labels that correspond to those used on each of the two splitter cable legs. Position the labels so that they will be clearly visible after the cable is plugged in.

4.Plug connector 0 into the 700A Jack.

5.Plug connectors 1and 2 into the cabinet. Connect only to a TN760B Tie Trunk CP.

6.Repeat procedure as required.

2-52