INSTALLATION

Make SIP Connections to Cabinet for 7300H Series Terminals

1.Select the cable label sheet (Figure 2-7)that identifies the cabinet (blue for #1, orange for #2, and green for #3).

2.On an octopus cable, attach an appropriate label (CAB1 SLOT8, for example) on the last flag-type cable tie and on the back of the hood of the 25-pair connector.

3.Connect the 25-pair connector end of the octopus cable to an appropriate receptacle (ZTN79) on the switch cabinet.

4.Run the octopus cable horizontally through the D-rings and mount it on the 50A Fanning Strip as shown in Figure 2-31.

5.Repeat the previous steps for each ZTN79 receptacle, so that all octopus cables linking 7300H Series terminals to the cabinet are labeled and run to the 50A Fanning Strip.

6.Check the Voice and Data Station Records Form to see which SIP adapter jacks are connected to 7300H Series terminals.

7.Connect port 1 of the first ZTN79 to the primary attendant console. Connect port 2 of the same CP to the primary attendant’s Direct Extension Selector (DXS) console (if present).

8.Connect the remaining plugs on the octopus cable to other 7300H Series terminal SIP jacks. Connect other ZTN79 CPs to other 7300H Series terminal adapters. Distribute the 34-button Deluxe and BIS terminals equally among all ZTN79 circuit packs.

9.Fill in the port ID of each station on the Voice and Data Station Records Form (Figure 2-26).

November 1995

2-73

Page 97
Image 97
ADTRAN 25 manual Make SIP Connections to Cabinet for 7300H Series Terminals