
APPENDIX C: System Additions or Changes
6.Power down the
7.Connect the cabinets, following the instructions under “Install System Cabinets” in Section 2.
8.Connect a #6 AWG copper wire between the ground block of the new cabinet and the ground block of Cabinet 1.
9.See Note. Make connections between the TDM bus of the new cabinet and the cabinet directly beneath. Move the bus terminator, following the instructions under “Install System Cabinets” in Section 2 .
Note: When properly installed, the light blue stripe on the extender cable is at the bottom of the cable and the lettering on the cable (SER=1, for example) is right side up.
10.Connect the receptacle end of the power cord to the plug at the rear of the new cabinet.
11.Connect the plug end of the power cord to the system’s quad ac outlet.
12.See DANGER. Recheck the electrical and ground connections that you just made.
Danger: Once power has been applied, do not insert hands or tools into the cabinet.
13.Power up the
14.Check the performance of the CPs in the new cabinet following the instructions under “Power Up and Initialize System” in Section 2.