ADTRAN 25 manual User Forced Warm Start System

MAINTENANCE

	ERROR MESSAGE			POSSIBLE SOLUTION
	AND DESCRIPTION
Unrecognized		Command:		Recoverable; no action required.
(STARLAN Interface			CP) This
error	is an	isolated	transient
condition.
User Forced Warm Start: System				Recoverable; no action required.
was warm started through the
SAT.
Warm Start:				Power supply may be out of
System was restarted for some				regulation (see Figure 4-2).Check
reason; translations are okay.				remaining errors in the alarm
				tables for associated problems.
Wink Too Short For Valid Signal:				Check equipment at far end to
For a delay dial or wink start				ensure that it is working and
outgoing trunk, if the wink from				translated properly per Figure 4-3.
the far end is less than the
minimum 100 ms, this error is
generated. The tie trunk remains
waiting for a valid signal.
Work Cycle Interrupt Test Failed:				Try to warm start the system
Work	cycle	interrupt problem.		through the SAT. If the problem
System most likely is stopped.				persists, check or replace the
				CPU/Memory CP.

4-46