ADTRAN 25 manual Missing Check CP slot reseat CP change

MAINTENANCE

	ERROR MESSAGE					POSSIBLE SOLUTION
	AND DESCRIPTION
Port		CP	Missing		B u t	Check CP slot; reseat CP; change
“Administered:			(Other		than	CP; or		remove	C P f r o m
CPU/Memory) Translated port CP						translations. If CP does not pass
that CPU cannot access.						power-up, replace CP.
Port CP Out Of Service: (Other						If the CP has not been removed
than	CPU/Memory)			Message		and the problem persists, check
occurs when a CP is removed						or replace the port CP.
from a cabinet. Error removed
when the CP passes power-up.
Port CP ROM Checksum Failure:						Try reseating the CP. If this error
The port CP has found that the						happens again, then replace the
checksum on its firmware is bad.						C P .
Port	Buffer		Full:	(STARLAN		If the reset is not successful,
Interface CP) This error resets the						reseat CP. If the reseat fails,
C P .						replace	the	CP.
Port Fault: For an auxiliary trunk,						C h e c k	wiring of		external
this message is logged when a						equipment (see Figure 4-7).
ground is expected from external
equipment and is not detected.
Port	Queue		Full:	(STARLAN		If the reset is not successful,
Interface CP) This error resets the						reseat CP. If the reseat fails,
CP .						replace the CP.
Program		Logic Inconsistent:				Reseat CP. If problem persists,
( O t h e r t h a n CPU/Memory)						replace	it.
Possible		hardware problem on
port	CP.
RAM Test Failed: CPU/Memory						Check	CPU/Memory		CP.
CP has failed the RAM test.

4-42