INSTALLATION

INSTALL ATTENDANT CONSOLE

Most systems will have one or two attendant consoles. Release 2 Version 1 and Release 3 systems support direct trunk attendant consoles (DTAC) or switched loop attendant consoles (SLAC). The system can support either one or two of the DTAC or SLAC consoles but not a combination of DTACs and SLACs. The installation procedures for the DTAC and SLAC are the same.

The primary (or first) attendant console is a DTAC and is located (by default translation) at the first port on the first ZTN79. (This can be changed to an SLAC console using the SAT.)

In some cases, a DXS console (Figure 2-35)may also be used. The DXS is the same for the DTAC and SLAC. The DXS is translated by default at the second port of the same ZTN79. Its port number can also be changed using the SAT.

1.Unpack the attendant console and DXS console (if supplied) and examine for damage.

2.Take the attendant console and a telephone line cord (D8W-87) with modular plugs on both ends (or two cords if a DXS is supplied) to the workstation where the attendant console will be used. The DXS also requires a KS-22911, L1 power supply for local power, a 400B2 Adapter, and a D6AP-87 Cord (all included with the DXS).

3.Insert one end of the D8W-87 Cord into the designated modular jack on the attendant console and the other end into a modular wall jack.

2-83

Page 108
Image 108
ADTRAN 25 manual Install Attendant Console