Safety Considerations
Safety Considerations
!CAUTION:
Electrostatic discharge damages electronic equipment. Do not touch any electronic component until you properly ground yourself.
To prevent damage to the equipment and yourself, follow these precautions:
■Familiarize yourself with the procedures necessary to prevent electrostatic damage to equipment.
■Shut off all power and remove all cables from equipment.
■Properly ground a work mat and wrist strap.
■Place the equipment on the work mat.
■Place the grounded wrist strap on your bare wrist. The wrist strap must contact your bare skin directly. Do not wear the wrist strap over your clothes.
Factory Assembled Systems
The factory performs assembly, load, and test (ALT) processes for most of the INTUITY hardware and software before shipping the system to the site. Use the information in this chapter to confirm that the system contains the hardware and software for your configuration.
After checking the installed hardware and software, perform all tasks not completed during ALT, such as connecting the voice and data lines, setting up and cabling the peripherals, and installing the switch communications software. Use one of the following checklists to make sure you complete all necessary tasks:
■INTUITY MAP/5 Installation Checklist,
■INTUITY MAP/40 Installation Checklist,
■INTUITY MAP/100 Installation Checklist,
Issue 2 December 1995
