AT&T 2400 manual Utils

Administer Serial Data Links

Use the following instructions to check or correct the default settings.

1.To access the edit forms used to change the serial data links, press FUNC to access the MCI MAIN MENU.

After you press the key, you see the MCI MAIN MENU as shown in the following example:

NEC 1-View 2-Utils 3-System

4-Setup 5-Logs

2.Select Utils from the menu by pressing 2 on the SID keypad.

After you press the key, you see the UTILS menu as shown in the following example:

UTILS 1-Login 2-Date/Time 3-Serial

3.Press 3 on the SID keypad to access the SERIAL menu.

After you press the key you see the SERIAL menu as shown in the following example:

SERIAL 1-Centrex 2-MCI

4.Enter the menu item number of the serial data link you need to edit.

When you select MCI or Centrex (SMDI) from the menu, you access four edit forms. Use the forms to set the serial data to the values your application requires. For example, press 2 on the keypad.

NOTE:

Both the MCI and Centrex edit forms appear the same, except for the edit form name. The MCI forms were chosen only as an example in this document. You can select either serial data link or both. You also can use the default values, as described earlier in this section.

5.After you press the key, you see the BAUD RATE edit form as shown in the following example:

MCI Baud Rate: 1200

<- ->1

Issue 2 December 1995 8-9