Switch Link Administration Screen Entries

Administering the INTUITY System for the NEAX Integration

Table 6-1. Switch Link Administration Screen Entries

Field	Description

Data link test	Indicates the test number sent to the switch to verify
number	whether the switch is active.
	Setting: A 7- or 10-digit number that is not an in-
	service extension number. The number of digits must
	agree with the setting for the dialstring size set on the
	SID. Refer to Chapter 3, "Switch Integration Planning",
	to find the dialstring size.

Serial port	Indicates which port on the multi-port circuit card in the
	INTUITY system is connected to the integration device.
	Setting: Press CHOICES (F2) to choose from a menu of
	available ports. Settings are in the format /dev/ttysax,
	where x is a letter a - h representing a port on the
	circuit card (from right to left). AT&T recommends that
	you use /dev/ttysaa as the serial port.

Baud rate	Indicates the rate at which the SID and the INTUITY
	system communicate.
	Setting: A baud rate of 1200, 2400, 4800, or 9600.
	Press CHOICES (F2) to choose from a menu of possible
	settings. This setting must agree the BAUD setting on
	the SID. AT&T recommends that you use a baud rate
	of 2400.

Comment	Use the field to enter a comment. Enter a maximum of
	30 characters. In your comment, do not use double
	quotation marks (“) or SHIFT + backslash (\).

6-4Issue 2 December 1995