NEAX 2400 Switch Administration
Administer Analog Voice Mail Ports
Each voice mail port connects to the switch through an analog line. For the integration process to function, you must configure the voice mail port analog lines in the same manner as you configure analog lines for a 2500 telephone set.
After configuring the ports on the switch, you must assign the analog port extension numbers on the SID configuration. You perform the SID processes in Chapter 8, "Switch Integration Device Administration".
NOTE:
Automated Attendant may not work properly on the NEAX 2400 with software version 4200 due to limitations in the NEAX 2400 switch.
Use the following instructions to administer the analog lines for the voice mail ports.
1.Log on to the NEAX 2400 Maintenance and Administration Terminal (MAT). For NEAX 2400 MAT logon instructions, contact your system administrator.
2.After you log on to the MAT, you see the 2400 Maintenance Command MENU as shown in Figure
*** 2400 MAINTENANCE COMMAND MENU ***
1SYSTEM CONTROL
2SYSTEM BACKUP
3MAKE BUSY CONTROL
4TRAFFIC DATA
5TEST
6STATION DATA
7TRUNK DATA
8NUMBERING PLAN
9SERVICE FEATURE DATA (1)
10SERVICE FEATURE DATA (2)
11SIGNAL TRANSLATION DATA
12RESTRICTION DATA
13INSTALLATION
14LIST UP
ENTER MENU ITEM NO [ 6 ]
