AT&T 2400 manual Neax Rolm Mitel Northern Quit

Installing SID Software on the INTUITY System

2.Select Floppy drive from the Software Install menu. The system responds:

Insert diskette into Floppy Drive 1. Type [go] when ready

or [q] to quit: (default: go)

3.Insert SID Switch Integration Package Disk 1 of 2 into the 3.5” floppy drive.

4.Press ENTER to install the software. The system responds:

Installation in progress. Do not remove the diskette.

The following		packages are available:
1	sid	INTUITY SID Switch Integration Package
		(486) 1.0-16

Select package(s) you wish to process (or ‘all’ to process all packages). (default: all) [?, ??, q]

5. Press ENTER to accept the default of all.

You will see a series of messages indicating that the software is being installed including a copyright statement. The system pauses at the following prompt:

Select type of switch:

1)NEAX

2)ROLM

3)MITEL

4)NORTHERN

5)QUIT

Enter Selection:

6.Enter 1 to select NEAX. You receive the following confirmation message:

Confirm: You selected option 1. (y/n)

7.Enter y to select yes. The installation continues. The system pauses when you see the following prompt:

Insert diskette 2 of 2 into Floppy Drive 1. Type [go] when ready

or [q] to quit: (default: go)

8.Remove Disk 1 of 2 from the floppy drive.

9.Insert Disk 2 of 2 into the floppy drive.

10.Press ENTER to continue the installation.

Following several screen messages, you see the Switch Link Administration screen as shown in Figure 5-2.The screen contains the system defaults that are automatically set when you load the software.

5-4Issue 2 December 1995