
Setting the Calling Party Identification Pad String
Setting the Calling Party Identification
Pad String
The Message Center Interface (MCI) protocol, used by the NEAX 2400 switch to communicate with the SID, provides calling and called party information consistent with the dial plan administered on the switch. The SID operates on Simplified Message Desk Interface (SMDI) protocol which uses a
Example: If you set the CPID pad string to 0000000 and the SID receives a caller ID of 245, the SMDI caller ID information becomes 0000245.
Setting the Message Waiting Indicator
Pad String
The Message Waiting Indicator (MWI) Pad String operates on the same basis as the CPID Pad String. As with the CPID Pad String, the SID uses a
Setting the Message Waiting Indicator
Feature
The MWI feature enables the INTUITY System to activate message waiting lamps. The SID sets the default value for this field to ENABLE, which activates the MWI feature. If you do not want the INTUITY System to activate the MWIs, change the field to DISABLE. Write the value on line 5 of Worksheet A.
Determining the Message Center
Interface Baud Rate
You must set the baud rate for the MCI link. The SID provides baud rate selections of 300, 1200, 2400, and 9600 baud and sets a default of 1200 baud. Make sure that the baud rate equals the dip switch settings on the MCI link switch I/O card. Write the MCI link baud rate on line 6 of Worksheet A. If you plan to use the default setting, write 1200 on the worksheet.
Issue 2 December 1995