
Switch Integration Device Administration
starts, you see the SMDI VIEW MODE screen as shown in the following diagram. below:
SMDI Idle
When the SID receives calls, the screen changes to show the SMDI packet being sent to the INTUITY System.
The screen appears similar to the following example:
SMDI MWI: | 0OP:MWI 0000202!. |
|
|
CPID: | ..MD0010001D 0000201 ... |
|
|
For more information on view modes, refer to Appendix B, "Using Views During Integration", in this document. Continue to the procedure in the next section, “Administer Serial Data Links.”
Administer Serial Data Links
The SID assigns default configurations to both the MCI and SMDI communication ports. You need to check the SID to make sure the defaults are set correctly and match the requirements of your integration. The SID sets the defaults shown in Table
Table 8-1. Serial Data Link Default Values
Link Type | Settings | |
|
|
|
SMDI: | 1200 baud | |
| 7 data bits | |
| 1 stop bit | |
| EVEN parity | |
|
|
|
MCI: | 1200 baud | |
| 7 data bits | |
| 1 stop bit | |
| EVEN parity | |
|
|
|