AT&T 2400 manual Define the Port as a Terminal, Assignment of System Data

Configuring the Message Center Interface Link

Define the Port as a Terminal

You must now designate that the port assigned to the MCI link is a terminal or two-way communication port. If you do not perform this step, the switch uses the port as a printer or one-way communication port.

Use the following instructions to define the MCI port type.

1.At the Installation Commands menu, shown in Figure 7-6.,enter 1 to select the System Data option. After you press ENTER , you see the Assignment of Station Data screen as shown in Figure 7-9.

Assignment of System Data
SYS:	1		SYS	: System Data Items
INDEX:	117	DATA:	01	1-System	Data 1
				2-System	Data 2
				3-System	Data 3
			TN	: Tenant Number
			INDEX: System Data Index
				System	Index
				1	0-255
				2	0-15
				3	0-31

DATA : System Data (Hexa-decimal)

Figure 7-9. Assignment of System Data

2.Enter 1 in the SYS field to tell the switch that the parameter changes effect the entire system.

3.Enter the index number in the INDEX field that corresponds to the port number you entered in the previous section, "Assign a Port for the Message Center Interface Link". Use Table 7-2to determine the index number for the port.

Issue 2 December 1995 7-15