2 Installing a BigIron RX-4 switch

FIGURE 20 Connecting a power cord to the power supply in a BigIron RX-4 chassis

 

 

 

3

 

 

2

 

 

 

1

 

1

Ground point

3

Cord retainer

2

Power cord

 

 

DANGER

If the installation requires a different power cord than the one supplied with the device, make sure you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance that the power cord can be used safely with the device.

4.For information about powering on the system, refer to “Powering-on the power source” on page 55.

Connecting DC power to a BigIron RX-4 chassis

You can provide your own DC power source for the BigIron RX-4 chassis. This is supported through use of a DC-to-DC power supply. DC power must be supplied at 48 V and 30 A. The DC-to-DC supply provides the DC power to the chassis at 12 V and 100 A.

DANGER

The procedure in this section is for qualified service personnel.

Follow the steps given below to connect a DC power source.

NOTE

The layout of the LEDs on your BigIron RX-4 DC power supply may be different from what is shown in Figure 21, due to multiple vendors; but the function is the same.

32

Brocade BigIron RX Series Hardware Installation Guide

 

53-1002483-03

Page 44
Image 44
Brocade Communications Systems S3-1002483-03 manual Connecting DC power to a BigIron RX-4 chassis