Brocade Communications Systems S3-1002483-03 manual Managing the BigIron RX Series chassis, Fans

4	Managing the BigIron RX Series chassis
		---POWERS ---
		AC Powers Are Used.
		Power 1: Installed (OK)
		Power 2: not present
		Power 3: not present
		Slot Power-On Priority:
		Slot1 (pri=1)
		Slot2 (pri=1)
		Slot3 (pri=1)
		Slot4 (pri=1)
		--- FANS ---
		Right Fan Tray: Fan 5: Status = OK, Speed = LOW (50%) (RPM 3333)
		Right Fan Tray: Fan 6: Status = OK, Speed = LOW (50%) (RPM 3409)
		--- TEMPERATURE READINGS ---
		Active Mgmt Module: 32.500C 54.625C (CPU)
		SNM1: 27.5C
		SNM2: 30.5C
		SNM3: 30.5C
		LP2 Sensor1: 41.0C
		Temperature Monitoring Poll Period is 60 seconds
		--- MISC INFO ---
		Backplane EEPROM MAC Address: 000a.80a0.2000
		The display shows the following information:
		TABLE 17	Chassis status and temperature information
		This field...	Displays...
		Powers

Power

BigIron RX-4: 1 – 3

BigIron RX-8: 1 – 4

BigIron RX-16: 1 – 8

Indicates whether an AC power supply is installed in the specified power supply slot and the status of the power supply, which can be one of the following:

•Installed (OK) – The power supply is functioning properly and supplying power to the chassis and installed modules.

•Failed – The power supply is not functioning and is not supplying power to the chassis and installed modules.

•Not present – There is no power supply installed in the slot.

Slot Power-On Priority	The configured power-on priority of each interface modules installed in a
	chassis slot.

Slot1 – Slot16

BigIron RX-4: Slot1 – Slot4

BigIron RX-8: Slot1 – Slot8

BigIron RX-16: Slot1 – Slot16

The priority of each chassis slot as configured by the lp-slot-prioritycommand. The priority can be 1 – 8, where 1 is the lowest priority and 8 is the highest priority. (The default priority is 1.) If the supply of power to the chassis falls below a minimum threshold, the chassis slots with the lowest priority will likely lose power. For information about using the lp-slot-prioritycommand, refer to “Changing priority of chassis slots for interface modules” on page 95.

Fans

Fan <number>	Information about fans in the BigIron RX Series chassis.
Status	The status of a fan can be one of the following:
	• OK – The fan is functioning properly and is keeping the temperature of
	each module within an acceptable temperature range.
	• Failed – The fan is not functioning properly or the fan control module
	cannot control the fan.

80	Brocade BigIron RX Series Hardware Installation Guide
	53-1002483-03