HP WebQoS Software manual Running setup -r, Opt/webqos/install/setup -r

Configuring HP WebQoS

Running the WebQoS setup Script

If you do not want to configure any web servers, enter NONE.

•Do you want to remove HP Admission Control?

This question appears only if you have installed an older version of WebQoS (HP ServiceControl) on your system. You must remove HP Admission Control in order to use this version of WebQoS. If you answer no, you will exit the script and you will not be able to use this version of WebQoS.

•Log the service statistics to MeasureWare?

This questions appears only if MeasureWare is already installed on your system.

WebQoS has been integrated with some components of HP OpenView. If you would like to view WebQoS reports, statistics, graphs, and events in HP OpenView, answer yes.

The setup script also starts the Service Control Agent.

Running setup -r

If you decide you no longer want to use WebQoS with your web server, run the following command.

/opt/webqos/install/setup -r

WebQoS configuration data is preserved in case you want to run WebQoS again later.

When you run setup -r, you must provide the following information:

•Continue running or exit the script?

If you want to continue using WebQoS, you can exit the script now.

•Select the type of web server on which you no longer want to use WebQoS.

Choose either NES (Netscape Enterprise Server) or Zeus.

•Enter the root pathname of the web server.

Chapter 3 39