
The POWER switch should be set to . Operate by touching the panel.
(1) Press FN to display PAGE1.
(2) Press MENU.
(3) Select CM SEARCH in , then press EXEC.
Le commutateur POWER doit être réglé sur .
Utilisez l’écran tactile.
(1) Appuyez sur FN pour afficher PAGE1.
(2) Appuyez sur MENU.
(3) Sélectionnez CM SEARCH dans , puis appuyez sur EXEC.
|
|
|
|
|
|
|
|
|
|
|
| CM SET |
|
|
| EXIT |
| ||||
|
| T I TLE |
|
|
|
|
| |||
|
| T I TLEERASE |
|
|
|
|
| |||
|
| T I TLE DSPL |
|
|
|
|
| |||
|
| CM SEARCH |
| ON |
|
|
| |||
|
| TAPE T I TLE |
| OFF |
|
|
| |||
|
| ERASE ALL |
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| EXEC |
| RET. |
| |
|
|
|
|
|
|
|
|
|
|
|
(4) Select OFF, then press EXEC.
(5) Press SEARCH MODE on the Remote Commander until the DATE SEARCH indicator appears.
(6) Press . on the Remote Commander to search for the previous date or press > on the Remote Commander to search for the next date. Your camcorder automatically starts playback at the point where the date changes. Each time you press . or >, your camcorder searches for the previous or next date.
To cancel searching
Press x on the Remote Commander or |
| on |
| ||
| ||
your camcorder. |
|
|
Note
If one day’s recording is less than two minutes, your camcorder may not accurately find the point where the recording date changes.
If the tape has a blank portion between recorded portions
Date search may not work correctly.
Cassette Memory
The cassette with Cassette Memory can hold six recording date data. If you search the date among seven or more data, see “Searching for the date without using Cassette Memory.”
98
(4) Sélectionnez OFF, puis appuyez sur EXEC.
(5) Appuyez sur la touche SEARCH MODE de la télécommande, jusqu’à ce que l’indicateur DATE SEARCH s’affiche.
(6) Appuyez sur . sur la télécommande pour rechercher la date précédente ou appuyez sur
>sur la télécommande pour rechercher la date suivante. Le caméscope démarre automatiquement la lecture à l’endroit où la date change. Chaque fois que vous appuyez sur . ou >, le caméscope recherche la date précédente ou suivante.
Pour annuler la recherche
Appuyez sur x sur la télécommande ou sur sur le caméscope.
Remarque
Si l’enregistrement d’une journée est inférieur à deux minutes, le caméscope risque de ne pas localiser avec précision le point où la date d’enregistrement change.
Si la cassette contient un passage vierge entre deux scènes
La recherche de la date risque de ne pas fonctionner correctement.
Cassette à puce
Une cassette à puce peut contenir six données de dates d’enregistrement. Si vous recherchez la date parmi sept dates ou plus,
«Recherche d’une date sur une cassette sans puce ».