Toshiba 4511, 3511 manual Main motor drive unit

[C] Main motor drive unit

(1)Take off the cleaner unit ( Chapter 11.7 [A]).

(2)Take off the rear cover ( Chapter 2.5.1 [P]).

(3)Take off the LGC board and the SYS board with

the whole case ( Chapter 2.5.2 [A] [C]).

(4)Remove 3 screws and take off the flywheel

( Chapter 9.5 [A]).

(5)Take off IH control PC board with the whole

cover ( Chapter 16.7 [M]).

(6)Take off the ozone exhaust fan with the whole cover ( Chapter 11.7 [J]).

(7)Remove 2 screws take off the ozone exhaust

duct ( Chapter 9.5 [B]).

(8)Remove 4 screws and take off the bracket. Note: This step can be omitted if the developer

motor drive unit and the transport motor drive unit are already taken out.

9

(9)Disconnect 2 connectors, release 2 harness clamps and remove 6 screws.

Take off the main motor drive unit.

(10)Remove 4 screws and take off the main motor. Note: When taking off only the main motor, it can be taken off by removing the LGC board and

SYS board with the whole case.

	Fig. 9-520
	Harness clamp
	Connector
	Harness clamp
Connector	Main motor drive unit
	Fig. 9-521

Main motor

Fig. 9-522

November 2003 © TOSHIBA TEC 9 - 13 e-STUDIO3511/4511 DRIVE SYSTEM